This is a gorgeous technique, that is SUPER easy to do : Etched Glass -using stamps!
Over the months I have received many emails asking for a how to, on this technique. Today I will show you just how simple it really is, with step by step instruction/ photos.
To start, this was a simple, round candle canister. I bought this for $4.99, and turned it into a pretty candle holder that would look fabulous anywhere in the house! If you purchased an etched glass canister it would cost triple that! Now you can make your own. With the holidays coming up, these would make fabulous inexpensive gifts for family, friends and teachers.
The possibilities for the items you can alter with this technique is limitless. So I hope you enjoy learning.
Stamp of choice-First Fruits, Glass container of choice (or mirror!), versmark ink, clear embossing powder, embossing buddy, heat tool, Armour Etch cream, sponge brush, Eclipse Tape (optional)
EDITED TO ADD: Etching cream can be found at Michaels in the section near the soap/candle isle. It took me an hour to find it because I did not think it was in that isle 😀
Before we get started there some things you should consider:
If you are heating glass, make sure is it a heat safe glass. Many times glass will crack or even explode when exposed to extreme heat!
Do not hold glass while heating. It gets very hot, and you could burn yourself.
Use a heat safe surface when heating your item. You don’t want to burn your work area.
Carefully examine the images you want to use. You don’t want to choose too finely detailed of an image because it can be hard to define what the image was. You need a nice balance of bold, and detailed. Consider the overall look of the completed project.
Clean glass with windex, and dry well! You don’t want ANY finger prints anywhere. They will show up!
Step 2) OPTIONAL
If necessary you may want to mask the glass. I use Eclipse Tape. It is sticky enough, and leaves no residue when removed.
Rub embossing buddy all over glass. This prevents embossing powder from sticking to unwanted areas, and ruining your etching. It will also show you if you do have finger prints on your glass, and need to re-clean it.
Carefully stamp the image in versamark ink. Because Papertrey Ink uses clear acrylic images you can see the image pressing into the glass! Since they are acrylic, they are also easier to stamp onto round surfaces.
Sometimes this take PRACTICE! Glass is slippery. So take your TIME stamping the image.
(NO photo for this step since it is hard enough stamping, let along photographing too! LOL!)
Apply a generous amount of embossing powder.
Tap of excess.
Heat set the image.
You will need to heat it until the powder turns SMOOTH-just like the glass.
CAUTION: Glass will get very hot! Don’t handle while heat setting, it is best to heat it on a heat safe surface.
NOTE: Also when doing more than one image on a surface, it is easier to heat set each one as you go. Keep in mind that the glass stays hot, and the melted powder remains warm, so you want to avoid smudging it, and avoid squishing it onto the table or getting more embossing powder on it, until the glass is cooled. Just be careful.
Once glass is COOLED-then apply a nice thick layer of etching cream.
Make sure you coat it thick and evenly!
The directions say leave on for 5 minutes. DON’T LISTEN TO THAT! LOL!
It really takes at LEAST 20 minutes to get a nice etched coating. If you don’t let it sit long enough it will hardly looked etched.
After you let it sit, go rinse the cream off under cold water. Take your fingernail, and scrap off the clear embossing powder. It will peel off.
Sorry for the photo. I wanted you to see the detail, and it is very difficult to get a nice picture of something like this so you see the detail.
I tied a Spring Moss satin ribbon around the top, then filled the bottom with pine cones and bought a battery tea light to put inside. No flame to worry about.
Now here it is lit up from the top view
Isn’t that so pretty?
Now it is your turn! Send me a link here if you decide to try it.
I hope you enjoyed learning all about etching cream here. I’d love to hear your thoughts.
As always, thank you for reading, and I hope you are inspired in some way to get an early start on those holiday gifts.